1999 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES

Component Component Location
A/C Compressor Cycling Switch In left front of engine compartment.
Air Bag Safing Switch Behind bottom of right kick panel. See Figure .
Brake Fluid Level Switch In left rear of engine compartment. See Figure .
Brake Pedal Position Switch Under left side of dash, on brake pedal support.
Clutch Pedal Switch (M/T) Under left side of dash, on clutch pedal support.
Dual-Pressure Switch In right front of engine compartment, on A/C line. See Figure .
Inertia Fuel Shut-Off (IFS) Switch Behind left kick panel. See Figure .
Low Coolant Level Switch In right front corner of engine compartment, in coolant reservoir. See Figure .
Oil Pressure Switch (2.0L) On right side of engine. See Figure .
Oil Pressure Switch (2.5L) On left side of engine. See Figure .
Park Brake Switch At base of parking brake lever.
Park/Neutral Position Switch (A/T) In left side of engine compartment, on top of transaxle.
Power Steering Pressure Switch (2.0L) On left front of engine. See Figure .
Power Steering Pressure Switch (2.5L) On right front of engine.
Seat Belt Buckle Switch In driver's seat belt buckle.
Start Inhibit Switch On clutch pedal support.
Stoplight Switch On bracket, above brake pedal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.