1998 Ford Windstar Base, 3.8 4FACTORY OEM SERVICE PROCEDURE

Engine Controls - Specifications - 3.8L: Capacities

BATTERY SPECIFICATIONS

Application & Group Cold Cranking Amps
3.8L 650
COOLING SYSTEM CAPACITIES

Application Qts. (L)
With Rear Heater 14.0 (13.2)
Without Rear Heater 12.0 (11.3)
CRANKCASE CAPACITIES

Application (1) Qts. (L)
3.8L 4.2 (4.0)
(1) Add 1/2 qt. if equipped with oil cooler.
TRANSMISSION & TRANSFER CASE CAPACITIES

Application Quantity
AX4S Auto. (1) 12.25 Qts. (11.6L)
(1) Use Mercon automatic transmission fluid.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.