Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES
| Component | Component Location |
|---|---|
| Cellular Phone In-Line Fuse | In cargo area, above left rear wheel well. |
| Engine Compartment Fuse/Relay Box | Front center of engine compartment, behind radiator. |
| I/P Fuse Panel | Under left corner of instrument cluster. See Figure . |
| Mega Fuse | Right side of engine compartment fuse/relay box. |
| Relay Center Box No. 1 | Near left side of battery, behind headlight. |
| Relay Center Box No. 2 | Behind dash, to right of steering column. |
| Relay Diode Center Box | At left rear corner of vehicle, below cargo flooring. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.