1998 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE

Test D: Window Stuck/Binding

  1. Window Motor Runs Slow  - Remove front door trim at suspect window. Actuate window in DOWN position. Check window glass runs. If there is an obstruction in glass run, remove obstruction, clean and lubricate glass, and retest system operation. If no obstruction is present, go to next step.
  2. Check Window Regulator Operation  - Actuate window to UP position and observe window regulator operation. If window regulator skips or binds, go to next step. If window regulator does not skip or bind, adjust regulator and guides, and retest system operation.
  3. Check Regulator & Motor  - Remove motor. See POWER WINDOW MOTOR  under REMOVAL & INSTALLATION. Carefully inspect motor and regulator gears. If there is damage to regulator gears, replace regulator and retest system operation. If there is no gear damage, replace window motor and retest system operation. See POWER WINDOW MOTOR  under REMOVAL & INSTALLATION.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.