Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Ford Ranger EVFACTORY OEM SERVICE PROCEDURE
Power Windows DTCS
POWER WINDOWS DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Source Module | Perform Test |
|---|---|---|
| B1302 | GEM | TEST A: ALL POWER WINDOWS ARE INOPERATIVE Accessory Delay Relay Coil Ckt Failure |
| B1304 | GEM | TEST A: ALL POWER WINDOWS ARE INOPERATIVE Accessory Delay Relay Coil Ckt Short To Battery |
| B1313 | GEM/CTM | TEST A: ALL POWER WINDOWS ARE INOPERATIVE Battery Saver Relay Coil Ckt Failure |
| B1315 | GEM/CTM | TEST A: ALL POWER WINDOWS ARE INOPERATIVE Battery Saver Relay Coil Ckt Short To Battery |
| GEM | NVM Configuration Failure Vehicle speed calibration data is not programmed into GEM/CTM. Use NGS tester configuration card help screen to program tire size and axle ratio. Retest system operation. If DTC B2141 is still present, replace GEM/CTM and retest system operation. |
C1751 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.