Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Ford Ranger EVFACTORY OEM SERVICE PROCEDURE
Cruise Control System DTCS
CRUISE CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Source Module | Perform Test |
|---|---|---|
| B2141 | GEM/CTM | Vehicle speed calibration data is not programmed into GEM/CTM. Use NGS tester configuration card help screen to program tire size and axle ratio. Retest system operation. If DTC B2141 is still present, replace GEM/CTM and retest system operation. NVM Configuration Failure |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.