Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Ford Econoline CustomFACTORY OEM SERVICE PROCEDURE
Intake Manifold Runner Control Actuator: Remove & Replace
WARNING: This page is about the Econoline E150, 4.2 2, which is a different variant/trim than selected.
FUEL INJECTION - GAS
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| E150,E250,V6, w/Intake Removal | Includes: R&I Intake Manifolds. | 4.3 | B | |
| E150,E250,V6, w/o Intake Removal | 1.0 | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.