Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Ford Contour Base, StandardFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS
| Component | Component Location |
|---|---|
| G1 | At left front side of engine compartment. |
| G2 | At front left rocker panel. |
| G10 | At right "A" pillar. See Figure . |
| G16 | At rear left side of luggage compartment. |
| G18 | At right front side of engine compartment. |
| G19 | At right front side of engine compartment. |
| G20 | At bottom of right "A" pillar. See Figure . |
| G21 | At bottom of right "A" pillar. See Figure . |
| G22 | At left front side of engine compartment. |
| G23 | At right "A" pillar. |
| G27 | At right "C" pillar. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.