Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Seats: Operation: Notes
The rack and pinion drive system consists of a reversible motor, switch and housing, vertical drive gears, and horizontal rack and pinion drives.
The pinion housing and motor assembly is attached to the movable section of the track and provides horizontal movement. Vertical movement is controlled by a worm and sector gear arrangement. Drive units are located at the front and rear of the seat. The tilt function is controlled by actuating either the front or rear sector gear. Pinion housing and motor are serviced as a complete assembly. Other components can be serviced individually.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
