Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Torque Specifications: Sedan
TORQUE SPECIFICATIONS (SEDAN)
| Application | Ft. Lbs. (N.m) |
|---|---|
| Front Strut Mounting Bracket Nut | 22-30 (30-40) |
| Front Tie Rod Lock Nut | 35-46 (47-63) |
| Rear Alignment Kit Cam Nut | 40-55 (54-74) |
| Rear Control Arm-To-Spindle Nut | 50-68 (68-92) |
| Rear Stabilizer Bar Bracket Bolt | 14-19 (19-26) |
| Rear Suspension Tension Strut-To-Spindle Nut | 34-46 (46-63) |
| Upper Rear Suspension Arm-To-Body Bolt | 72-97 (98-132) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
