Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Door Lock Switch Test
Disconnect and remove power door lock switch. See DOOR LOCK SWITCH under REMOVAL & INSTALLATION. With switch "U" button depressed, measure resistance between switch terminals No. 2 and 3. See Fig 1 . Resistance should be less than 5 ohms. With switch "L" button depressed, measure resistance between switch terminals No. 3 and 5. Resistance should be less than 5 ohms. If resistances are not as specified, replace switch.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.