1997 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

DTC B1549

WARNING: This page is about a different car, the 1997 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure Switch Is Not Active  - Ensure power window switches are not pressed. Clear DTCs. Perform ON-DEMAND SELF-TEST. See ON-DEMAND SELF-TEST in MODULE COMMUNICATIONS NETWORK article. If DTC B1549 is not indicated, go to next step. If DTC B1549 is indicated, go to step 3).
  2. Ensure Switch Is Not Sticking  - Connect New Generation Star (NGS) tester to Data Link Connector (DLC). Access the following window regulator control switch PIDs:
    • RRPW_SW_ - Right Rear Power Window Switch
    • LRPW_SW_ - Left Right Rear Power Window Switch
    • P_PW_SW_ - Passenger Power Window Switch
    • D_PW_SW_ - Driver Power Window Switch

    Press and release each power window switch several times. If PID indicates button does not release within one second of when each switch is released, go to next step. If PID indicates button releases within one second of when each switch is released, system is operating normally. Continuous DTC would be set if any power window master switch was pressed for longer than 2 minutes.

  3. Switch Test  - Connect New Generation Star (NGS) test to Data Link Connector (DLC). Access the following window regulator control switch PIDs:
    • RRPW_SW_ - Right Rear Power Window Switch
    • LRPW_SW_ - Left Right Rear Power Window Switch
    • P_PW_SW_ - Passenger Power Window Switch
    • D_PW_SW_ - Driver Power Window Switch

Remove Driver's Door Module (DDM), but DO NOT disconnect. Remove bezel from DDM. If PID still indicates a sticking switch, replace DDM. Retest system. If PID does not indicate a sticking switch, replace bezel. Retest system.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.