WARNING: This page is about a different car, the 1997 Lincoln Mark VIII. However, it is still accessible from the selected car via links, so may be relevant.

Enter 5-digit permanent entry code at keypad. Within 5 seconds of pressing last digit, press 1/2 button on keypad to activate programming mode. Enter new 5-digit keypad code. To associate new code with personality position 1, press 1/2 button within 7.5 seconds of entering last digit of new code.
To associate new code with personality position 2, press 3/4 button within 7.5 seconds of entering last digit of new code. Door locks will lock and unlock confirming new code is programmed. If additional codes are to be programmed, begin entering code within 7.5 seconds of pressing last button.
After all new keypad codes are programmed:
- Remote transmitters can be programmed within 7.5 seconds of entering last keypad code.
- Press keypad buttons 7/8 and 9/0 simultaneously to exit program mode.
- Wait 7.5 seconds and driver's door module will exit program mode.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Section 16 (Keyless Entry System - Remote): Programming: Keypad

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?