Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Timing
- Ensure engine is at operating temperature, all accessories are off, and transmission is in Park or Neutral. Set parking brake. Ensure idle speed is correct.
- Connect timing light to No. 1 spark plug wire. Remove shorting bar from double-wire Spark Output (SPOUT) connector. SPOUT connector is located near negative terminal of battery. Start engine. Check base ignition timing. See BASE IGNITION TIMING table.
- If timing is not correct, loosen distributor hold-down bolt. Adjust timing as necessary. Turn engine off. Install shorting bar in double-wire SPOUT connector. Start engine. Check computed ignition timing. Computed ignition timing should be advanced beyond base timing.
BASE IGNITION TIMING
| Application | Degrees BTDC @ Idle | ||
|---|---|---|---|
| 2.0L (VIN A) | (1) 9-11 | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
