Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Ford Escort Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Axle Nut (Front) | 174-235 (235-319) | |
| Brake Caliper Bolt | ||
| Front | 33-36 (45-49) | |
| Rear | 25-29 (34-39) | |
| Brakeline Flare Nut | 10-16 (13-22) | |
| Lower Ball Joint Clamp Bolt | 25-42 (34-57) | |
| Master Cylinder-To-Booster Nut | 8-12 (10-16) | |
| Rear Engine Support Bolt/Nut | 47-66 (64-89) | |
| Spindle Nut (Rear) | 130-174 (177-235) | |
| Stabilizer Bar Link Nut | 27-40 (36-54) | |
| Tie Rod End Nut | 25-34 (34-46) | |
| Transaxle Mount Nut | 27-38 (37-51) | |
| Wheel Speed Sensor Mounting Bolt | 14-18 (19-25) | |
| Wheel Lug Nut | 65-87 (88-118) | |
| Bleeder Screws | 53-78 (5.9-8.8) | |
| INCH Lbs. (N.m) | ||
| ABCM Mounting Bolt/Nut | 62-89 (7-10) | |
| ABCM Connector Mounting Bolt/Nut | 6-7 (53-62) | |
| ABS Relay Mounting Bolt | 62-89 (7-10) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.