Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997CONTOUR LX, 2.5 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (MODULE COMMUNICATIONS NETWORK)TESTINGTEST K: DRIVER'S DOOR MODULE (DDM) DOES NOT RESPOND TO SCAN TESTER
1997 Ford Contour LX, 2.5 L, Standard
Test K: Driver's Door Module (DDM) Does Not Respond To Scan Tester
1997 Ford Contour LX, 2.5 L, StandardSECTION Test K: Driver's Door Module (DDM) Does Not Respond To Scan Tester
WARNING: This page is about a different car, the 1997 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition switch is in OFF position. Disconnect 84-pin harness connector C217. Harness connector C217 is located behind driver's side of instrument panel. See Figure .
- Using ohmmeter, check resistance between terminal No. 76 (Tan/Orange wire) on male side of harness connector C217 and terminal No. 2 (Tan/Orange wire) on Data Link Connector (DLC). See Figure and Figure .
- If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open circuit on Tan/Orange wire between DLC and harness connector C217. Repeat TEST A .
- Using ohmmeter, check resistance between terminal No. 77 (Pink/Light Blue wire) on male side of harness connector C217 and terminal No. 10 (Pink/Light Blue wire) on DLC. See Figure and Figure .
- If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open circuit on Pink/Light Blue wire between DLC and harness connector C217. Repeat TEST A .
- Disconnect 16-pin connector C523 from Driver's Door Module (DDM). The DDM is located inside the driver's door. See Figure .
- Using ohmmeter, check resistance between terminal No. 76 (Tan/Orange wire) on female side of harness connector C217 and terminal No. 6 (Tan/Orange wire) on connector C523. See Figure and Fig 1 .
- If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open circuit on Tan/Orange wire between harness connector C217 and connector C523. Repeat TEST A .
- Using ohmmeter, check resistance between terminal No. 77 (Pink/Light Blue wire) on female side of harness connector C217 and terminal No. 5 (Pink/Light Blue wire) on connector C523. See Figure and Fig 1 .
- If resistance is 5 ohms or less, replace DDM. Repeat TEST A . If resistance is more than 5 ohms, repair open circuit on Pink/Light Blue wire between harness connector C217 and connector 523. Repeat TEST A .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.