Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Ford Contour Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Component Locations
WARNING: This page is about a different car, the 1998 Mercury Mountaineer and 1998 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Inertia Fuel Shutoff Switch | In Dash Below Radio |
| Instrument Panel Fuse Panel | Above Left Of Steering |
| ************************ | Column |
| PATS Module | Behind Right Side Of |
| ************************ | Instrument Panel |
| Power Distribution Box | Left Side Of Engine |
| ************************ | Compartment |
| Starter Relay | In Power Distribution Box |
| Starter Relay Diode | In Underhood Fuse Box |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.