1997 Ford Contour Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal & Installation

WARNING: This page is about a different car, the 1997 Mercury Tracer and 1997 Ford Escort. However, it is still accessible from the selected car via links, so may be relevant.

Remote Anti-Theft Personality (RAP) module is also known as control module. Disconnect negative battery cable. On sedans, remove right quarter trim panel. On wagons, remove left quarter trim panel. On all models, disconnect 2 RAP module electrical connectors. Remove 2 RAP module mounting nuts and remove RAP module. Lift 2 tabs and remove RAP module from bracket. To install, reverse removal procedure. Tighten RAP module mounting nuts to 6.8-8.5 INCH lbs. (9-11.5 N.m).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.