Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
All Windows Operate With Ignition Off
Turn ignition switch to OFF position. Remove accessory delay relay and one-touch down relay from relay module located behind center of instrument panel. Turn ignition switch to RUN position. Measure voltage at accessory delay relay socket Light Blue/Black wire terminal. If voltage is present, repair short to power in Light Blue/Black wire. If voltage is not present, replace accessory delay relay. Clear DTCs and retest system.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.