1997 Ford Contour Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Window Stuck/Binding

  1. Function Test  - Remove trim panel at suspect window. Actuate power window switch for down operation. Observe glass in guides. If there are no obstructions in glass guides, go to next step. If obstructions are observed, clear obstructions and lubricate glass guides. Retest system.
  2. Window Regulator Operation Check  - Actuate power window switch for up operation. Observe window motion. If regulator does not skip or bind, go to next step. If regulator skips or binds, loosen glass guide retaining screws and adjust glass guides as necessary. Retest system.
  3. Regulator & Power Window Motor Check  - Inspect regulator and drive motor gears for excessive wear or damage. If excessive wear or damage is found, repair or replace regulator and/or motor. If excessive wear or damage are not found, lubricate regulator and retest system.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.