1997 Ford Aspire 4D Hatchback, StandardFACTORY OEM SERVICE PROCEDURE

Communication Error

If scan tool will not communicate with PCM (no response on scan tool), a communication error exists. A communication error could be caused by the following:

  • Operator error.
  • Vehicle wiring.
  • DLC terminals damaged.
  • PCM malfunction.
  • Low battery voltage.

The scan tool may display a 2-digit code indicating communication status. These codes are not DTCs. Some status codes indicate normal communication function. See COMMUNICATION CODES table. If scan tool indicates a communication error (e.g., Code 10), go to CIRCUIT TEST QAΒ  for diagnostic procedure.

COMMUNICATION CODES

Code Description
00 General Affirmative - PCM Received A Valid Request From Scan Tool
10 General Reject - PCM Will Not Respond
11 Mode Not Supported - PCM Is Not Capable Of Performing A Requested Test
12 Invalid Data Format - An Unrecognized Character Is Inserted Into A String Of Data
21 PCM Is Busy At Time Of Request - PCM Is Already Performing A Test At Time Another Test Is Being Requested
22 Entry Conditions Not Correct - Usually Operator Error (i.e., Engine Not Running, Etc.)
23 Results Not Done - Request Received, But PCM Is Not Ready To Respond
50 Upload Not Accepted - Request Cannot Be Accomplished Due To Fault Condition
61 Normal Exit With Results - PCM Completed A Valid Request (Test) & A DTC Was Recorded
62 Normal Exit, No Results - PCM Completed A Valid Request & No DTC Recorded
63 Abnormal Exit With Results - While Performing Test, Error Occurred, But PCM Has Results
64 Abnormal Exit Without Results - While Performing Test, Error Occurred, & No Results are Available
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.