Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Ford Windstar Base, 3.8 4FACTORY OEM SERVICE PROCEDURE
Test D: Abs Module Not Responding To Scan Tool
WARNING: This page is about a different car, the 1997 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
- Check For Open In Circuit No. 70 Between DLC & C101
Turn ignition off. Disconnect harness connector C101 (70-pin connector located on left side of firewall). See Figure and Figure. Measure resistance of circuit No. 70 (Light Blue/White wire) between C101 terminal No. 61 and DLC terminal No. 7. If resistance is less than 5 ohms, go to next step. If resistance is greater than 5 ohms, repair open circuit No. 70 (Light Blue/White wire). Repeat DATA LINK DIAGNOSTICS under COMMUNICATION NETWORK DIAGNOSTICSΒ to confirm repair. - Check For Open In Circuit No. 70 Between C101 & ABS Module
Disconnect ABS module harness connector. Measure resistance of circuit No. 70 (Light Blue/White wire) between C101 terminal No. 61 and ABS module connector terminal No. 5. If resistance is less than 5 ohms, go to next step. If resistance is greater than 5 ohms, repair open circuit No. 70 (Light Blue/White wire). Repeat DATA LINK DIAGNOSTICS under COMMUNICATION NETWORK DIAGNOSTICSΒ to confirm repair. - Check ABS Module Connector
Inspect ABS module harness connector for damage or corrosion. Repair if necessary. If connector is okay, replace ABS module. Repeat DATA LINK DIAGNOSTICS under COMMUNICATION NETWORK DIAGNOSTICSΒ to confirm repair.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
