Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Ford Windstar Base, 3.8 4FACTORY OEM SERVICE PROCEDURE
Test B: Abs/TC Module Not Responding To Scan Tool
WARNING: This page is about a different car, the 1997 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
- Check For Open In Circuit No. 914
Turn ignition off. Disconnect harness connector C101. See Figure and Figure. Inspect connector for damage or corrosion and repair if necessary. Measure resistance of circuit No. 914 (Tan/Orange wire) between harness connector C101 and DLC pin No. 2. See Figure. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open Tan/Orange wire. - Check For Open In Circuit No. 915
Leave ignition off. Measure resistance of circuit No. 915 (Pink/Light Blue wire) between DLC pin No. 10 and harness connector C101 terminal No. 55. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Pink/Light Blue wire. - Check For Open In Circuit No. 914 Between C101 & ABS/TC Module
Turn ignition off. Disconnect Anti-Lock Brake System/Traction Control (ABS/TC) module harness connector. Inspect connector for damage or corrosion and repair if necessary. Measure resistance of circuit No. 914 (Tan/Orange wire) between harness connector C101 terminal No. 56 and ABS/TC module connector. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Tan/Orange wire. - Check For Open In Circuit No. 915 Between C101 & ABS/TC Module
Turn ignition off. Measure resistance of circuit No. 915 (Pink/Light Blue wire) between harness connector C101 terminal No. 55 and ABS/TC module connector. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Pink/Light Blue wire. - Check Connector
Inspect ABS/TC module harness connector for damage or corrosion. Repair if necessary. If connector is okay, replace ABS/TC module. Repeat DATA LINK DIAGNOSTICSΒ under COMMUNICATIONS NETWORK DIAGNOSTICS to confirm repair.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
