Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Ford Windstar Base, 3.8 4FACTORY OEM SERVICE PROCEDURE
Pinpoint Test "A"
- Turn ignition off. Disconnect harness connector No. 1. See Figure and Fig 1 . Inspect connector for damage or corrosion and repair if necessary. Measure resistance between harness connector No. 1 Tan/Orange wire terminal and DLC pin No. 2 (Tan/Orange wire). See Fig 2 . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Tan/Orange wire circuit.
- Leave ignition off. Measure resistance between harness DLC pin No. 10 (Pink/Light Blue wire) and connector No. 1 Pink/Light Blue wire terminal. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Pink/Light Blue wire circuit.
- Turn ignition off. Disconnect harness connector No. 2. See Figure and Fig 1 . Inspect connector for damage or corrosion and repair if necessary. Measure resistance between harness connector No. 1 Tan/Orange wire terminal and connector No. 2 Tan/Orange wire terminal. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Tan/Orange wire circuit. 6 4) Turn ignition off. Measure resistance between harness connector No. 1 Pink/Light Blue wire terminal and connector No. 2 Pink/Light Blue wire terminal. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Pink/Light Blue wire circuit.
- Disconnect PCM wiring harness connector. See Figure and Fig 1 . Measure resistance between harness connector No. 2 Tan/Orange wire terminal and PCM connector pin No. 16 (Tan/Orange wire). See Fig 3 . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Tan/Orange wire circuit.
- Turn ignition off. Measure resistance between harness connector No. 2 Pink/Light Blue wire terminal and PCM connector pin No. 15 (Pink/Light Blue wire)terminal. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair Pink/Light Blue wire circuit.
- Inspect PCM wiring harness connector for damage or corrosion. Repair if necessary. If connector is okay, replace PCM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
