Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Function Selector Knob
WARNING: This page is about a different car, the 1995 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.
Function selector knob operates recirculated/fresh air door, floor door, panel door and defrost door vacuum motors. Selection of VENT, FLOOR, OFF, MIX or defrost directs airflow to chosen outlets.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.