1996 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 18 (Heater System): Description

WARNING: This page is about a different car, the 1995 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.

Heater system is a blend-air type. Outside airflow is received through inlet duct to be warmed in the heater case and distributed to selected outlets. The temperature blend door adjusts passenger compartment temperature by allowing more or less airflow through heater core. The function selector knob controls airflow to selected outlets.

WARNING: To avoid injury from accidental air bag deployment, read and carefully follow all SERVICE PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM procedures in the AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIPMENT section.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.