1996 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Wire Repair: Notes

WARNING: This page is about a different car, the 1997 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.

To repair damage to sensor wiring and wiring harnesses, note following conditions and proceed to Repair Procedure.

  • All wire splice connections must be staggered at least 2" (50 mm) apart.
  • Use proper size butt connectors and shrink tubing for size of wire being spliced.
  • All repaired connections must be waterproofed using heat shrink tubing.
  • Use of transparent butt connectors allows inspection of finished crimped connector to ensure proper connection.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.