1996 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 17 (Supplemental Inflatable Restraint System): Adjustments: CLOCKSPRING

WARNING: This page is about a different car, the 1997 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.

If clockspring has been rotated, clockspring alignment must be adjusted. To adjust clockspring, ensure front wheels are in straight ahead position. Rotate clockspring clockwise until it stops. Rotate clockspring counterclockwise 2 3/4 turns. Align marks on clockspring with marks on outer housing. Clockspring is now adjusted properly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.