Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
One Mirror Inoperative
- Perform appropriate mirror switch component testing. See MIRROR CONTROL SWITCH . Replace switch if necessary. If mirror switch is okay, disconnect harness connectors from mirror control switch and inoperative mirror.
- Check continuity of all wires between control switch and inoperative mirror. Repair any open wires. Check for short to ground on inoperative mirror motor circuits. Repair as necessary. If all wires between mirror switch and inoperative mirror are okay, replace mirror motor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.