1996 Ford Explorer 2D Utility, AWDFACTORY OEM SERVICE PROCEDURE

Fuel System Pressure Release

WARNING: Always relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components.
  1. Remove fuel tank cap. Connect Fuel Pressure Gauge (T80L-9974-B) to pressure relief valve (Schrader valve), located on fuel injection manifold rail. Place fuel pressure gauge in a suitable container. Using gauge, release pressure from system.
  2. If fuel pressure gauge is not available, disconnect Inertia Fuel Shutoff (IFS) switch. See INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATIONΒ  table. Remove fuel cap to release fuel tank pressure. Crank engine for 15 seconds to release system pressure.
INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION

Application Location
Explorer Under Instrument Panel, Near Right Side Of Transmission Hump
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.