Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Ford Aspire 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Checks: Spark
- Crank engine. Check for a strong Blue spark at each spark plug wire by using a high output spark tester. Verify resistance of each spark plug wire is 4-7 k/ohms per foot.
- Unplug and inspect all related ignition system connectors and harnesses. Clean or repair as necessary and recheck spark. If still no spark, go to IGNITION COIL POWER SOURCE.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.