Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Windstar LXFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System DTCS
ANTI-LOCK BRAKE SYSTEM DTCS
| Diagnostic Trouble Code | Component | Action |
|---|---|---|
| B1342 | ABCM Failure | Replace ABCM |
| C1184 | ABS SYSTEM TIMEOUT | PINPOINT TEST P |
| C1220 | Yellow ABS Light | PINPOINT TEST A |
| C1225/C1226 | Red BRAKE Light | PINPOINT TEST B |
| C1198/C1200 | Iso, Front Left (IFL) | PINPOINT TEST Q |
| C1194/C1196 | Dump, Front Left (OFL) | PINPOINT TEST Q |
| C1214/C1216 | Iso, Front Right (IFR) | PINPOINT TEST Q |
| C1210/C1212 | Dump, Front Right (OFR) | PINPOINT TEST Q |
| C1250/C1252 | Iso, Rear Left (IRL) | PINPOINT TEST Q |
| C1242/C1244 | Dump, Rear Left (ORL) | PINPOINT TEST Q |
| C1254/C1256 | Iso, Rear Right (IRR) | PINPOINT TEST Q |
| C1246/C1248 | Dump, Rear Right (ORR) | PINPOINT TEST Q |
| C1155 | Front Left Sensor (Static) | PINPOINT TEST C |
| C1158/C1233 | Front Left Sensor (Dynamic) | PINPOINT TEST D |
| C1145 | Front Right Sensor (Static) | PINPOINT TEST E |
| C1148/C1234 | Front Right Sensor (Dynamic) | PINPOINT TEST F |
| C1175 | Rear Left Sensor (Static) | PINPOINT TEST G |
| C1178/C1236 | Rear Left Sensor (Dynamic) | PINPOINT TEST H |
| C1165 | Rear Right Sensor (Static) | PINPOINT TEST J |
| C1168/C1235 | Rear Right Sensor (Dynamic) | PINPOINT TEST K |
| C1265 | Shorted Red BRAKE Light Relay | PINPOINT TEST B |
| C1095/C1096 | Pump Motor | PINPOINT TEST L |
| C1185 | Internal Power Relay (Open) | PINPOINT TEST M |
| C1222 | Wheel Speed Error | PINPOINT TEST P |
| No Diagnostics | PINPOINT TEST N | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.