Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Taurus V6-232 3.8LFACTORY OEM SERVICE PROCEDURE
Control Assembly: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the instrument panel finish applique.

3. Remove the four Torx head screws retaining the control head. Pull the control head away from the instrument panel into a position which provides access to the rear connectors.
4. Disconnect the two harness connectors from the control assembly by depressing the latches at the top of the connectors and pulling.
INSTALLATION
CAUTION: Push on the vacuum harness retaining nuts. Do not attempt to screw them onto the post.
1. Connect the wire connectors and the vacuum harness to the A/C control using new pushnuts.
2. Position the A/C control to the instrument panel opening and install the four retaining screws.
3. Install the instrument panel finish applique.
4. Connect the battery ground cable.
NOTE: On vehicles equipped with Electronic Engine Control (EEC), when the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the EEC processor relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
5. Check the system for proper operation.
1. Disconnect the battery ground cable.
2. Remove the instrument panel finish applique.
Climate Control Assembly:
3. Remove the four Torx head screws retaining the control head. Pull the control head away from the instrument panel into a position which provides access to the rear connectors.
4. Disconnect the two harness connectors from the control assembly by depressing the latches at the top of the connectors and pulling.
INSTALLATION
CAUTION: Push on the vacuum harness retaining nuts. Do not attempt to screw them onto the post.
1. Connect the wire connectors and the vacuum harness to the A/C control using new pushnuts.
2. Position the A/C control to the instrument panel opening and install the four retaining screws.
3. Install the instrument panel finish applique.
4. Connect the battery ground cable.
NOTE: On vehicles equipped with Electronic Engine Control (EEC), when the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the EEC processor relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
5. Check the system for proper operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
