Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Taurus V6-232 3.8LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Module: Description and Operation
Control Processor, Electronic Door Lock
The electronic door lock control processor is located under the package tray in luggage compartment behind the LH quarter trim panel (station wagon).
- It contains a radio receiver that receives a signal from the keyless entry remote transmitter through the electronic door lock control processor antenna, and sends the appropriate command to the power door locks, the horn relay, the indicator flasher, or the anti-theft warning system.
- The electronic door lock control processor is equipped with a battery backup which holds the programmed code in memory in the event the vehicle battery is disconnected.
The electronic door lock control processor is located under the package tray in luggage compartment behind the LH quarter trim panel (station wagon).
- It contains a radio receiver that receives a signal from the keyless entry remote transmitter through the electronic door lock control processor antenna, and sends the appropriate command to the power door locks, the horn relay, the indicator flasher, or the anti-theft warning system.
- The electronic door lock control processor is equipped with a battery backup which holds the programmed code in memory in the event the vehicle battery is disconnected.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.