Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Taurus V6-182 3.0LFACTORY OEM SERVICE PROCEDURE
General Engine Specifications
Engine Size 3.0 liters
VIN Code [02] U
Fuel System SFI
Bore & Stroke 3.50 in x 3.15 in
Compression Ratio 9.3:1
Net HP @ RPM [03] 140 @ 4800
Maximum Torque @ RPM 165 ft lb @ 3000
Normal Oil Pressure 40.0-60.0 psi [01]
SFI -- Sequential Fuel Injection.
[01] -- At 2500 RPM W/engine at operating temperature.
[02] -- The eighth digit of the VIN denotes engine code.
[03] -- Ratings are net-as installed in vehicle.
VIN Code [02] U
Fuel System SFI
Bore & Stroke 3.50 in x 3.15 in
Compression Ratio 9.3:1
Net HP @ RPM [03] 140 @ 4800
Maximum Torque @ RPM 165 ft lb @ 3000
Normal Oil Pressure 40.0-60.0 psi [01]
SFI -- Sequential Fuel Injection.
[01] -- At 2500 RPM W/engine at operating temperature.
[02] -- The eighth digit of the VIN denotes engine code.
[03] -- Ratings are net-as installed in vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.