Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Taurus V6-182 3.0LFACTORY OEM SERVICE PROCEDURE
Air Flow Meter/Sensor: Service and Repair
REMOVAL
CAUTION: The Mass Air Flow Sensor (MAF) is a calibrated unit. Service hot wire engine element and housing as a complete assembly.
1. Remove air cleaner outlet tube (9B659).
2. Disconnect engine control sensor wiring connector from MAF sensor.
3. Remove four retaining bolts.
4. Carefully remove MAF sensor. Discard gasket.
INSTALLATION
1. Position MAF sensor with new gasket onto air cleaner cover.
2. Install four retaining bolts. Tighten to 3.5 Nm (25 in lb).
3. Install air cleaner outlet tube.
4. Connect engine control sensor wiring connector to MAF sensor.
5. Start engine and check for vacuum leaks.
CAUTION: The Mass Air Flow Sensor (MAF) is a calibrated unit. Service hot wire engine element and housing as a complete assembly.
1. Remove air cleaner outlet tube (9B659).
2. Disconnect engine control sensor wiring connector from MAF sensor.
3. Remove four retaining bolts.
4. Carefully remove MAF sensor. Discard gasket.
INSTALLATION
1. Position MAF sensor with new gasket onto air cleaner cover.
2. Install four retaining bolts. Tighten to 3.5 Nm (25 in lb).
3. Install air cleaner outlet tube.
4. Connect engine control sensor wiring connector to MAF sensor.
5. Start engine and check for vacuum leaks.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.