1995 Ford Probe GT, AutomaticFACTORY OEM SERVICE PROCEDURE

Switch Performance Check

Check switch in ON and OFF positions. Install breakout box, leaving PCM disconnected. Turn ignition on. Measure voltage between breakout box test pin of switch being tested and ground. Switch should function as follows:

  • BOO Depress brake pedal to close switch.
  • DEF Turn rear defroster on to close switch.
  • HDLT Turn headlight on to close switch.
  • VST Switch is closed when engine is cranking.
Fig 1: Brake On/Off Switch Connector Terminals
G94E31702
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.