Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pressure Release
Remove fuel pump relay or disconnect Inertia Fuel Shutoff (IFS) switch. Fuel pump relay is located in engine compartment main fuse panel. IFS switch is located luggage compartment. Start engine and operate it until it stalls. Turn ignition off. Reconnect fuel pump relay or IFS switch. See INERTIA FUEL SHUTOFF (IFS) SWITCH under ENGINE SENSORS & SWITCHES.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.