Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Pinpoint Test D - Anti-Theft System Does Not Operate From Remote Transmitter
- Turn ignition off. Unplug Black REM connector and 20-pin CPU connector. Measure resistance of Yellow/Red wire between REM connector and 20-pin CPU connector. Measure resistance of Yellow/Red wire between REM connector and ground.
- Resistance between REM connector and CPU should be less than 5 ohms. Resistance between REM connector and ground should be more than 10,000 ohms. If resistance is as specified, temporarily substitute known good REM, then retest system. If resistance is not as specified, repair Yellow/Red wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.