Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Explorer 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | INCH Lbs. (N.m) |
|---|---|
| Belt Line Weatherstrip Nut | 13-20 (1.4-2.3) |
| Body Side Window-to-Body Nuts | 9-17 (1-2) |
| Equalizer Bracket Nut | 80-123 (9-14) |
| Guide-to-Glass Bracket | 62-123 (7-14) |
| Motor And Drive Screws | 50-84 (6-9) |
| Regulator Inner Panel | 80-123 (9-14) |
| Run Attaching Screws | 62-132 (7-14) |
| Stabilizer Attaching Screws | 80-123 (9-14) |
| Window Regulator Base Plate Nuts | 80-123 (9-14) |
| Window Regulator Electric Drive Screws | 50-84 (6-9) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
