Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Explorer 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Disabling One-Touch Window (Ranger & Explorer)
- Close both front doors.
- Key on.
- Key off.
- Remove key from ignition switch.
- Press and hold the down window switch to enable/disable the one-touch window feature.
- Reinsert the key into the ignition switch within two seconds after pressing the down window switch.
- Continue to hold the switch until a two-second tone is heard.
- Release the switch while the tone is active.
- After the two-second tone, the following confirmation beep sequences will be heard:
- One beep means feature is disabled.
- Two beeps mean feature is enabled.
- Repeat the procedure again to toggle back and forth.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
