1995 Ford Explorer 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Single Switch

  1. Use a self-powered test light or a Digital Volt-Ohmmeter to test the window regulator control switch.
  2. With the switch in the neutral position, there should be continuity between terminals No. 1 and 3, 2 and 5 and 4 and 6. See Fig 1.
  3. With the toggle switch pushed downward, there should be continuity between terminals No. 2, 4 and 5, and 1 and 3. Terminal No. 6 should be disconnected from any other terminal. See Fig 1.
  4. With the toggle switch pushed upward, there should be continuity between terminals No. 2, 3 and 5, and 4 and 6. Terminal No. 1 should be disconnected from any other terminal. See Fig 1.
  5. If the window regulator control switch does not test as stated, replace the window regulator control switch.
Fig 1: Terminal Call Outs At Switch
G00088815Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.