Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Crown Victoria BaseFACTORY OEM SERVICE PROCEDURE
Ignition Switch
- Check for continuity between specified terminals with ignition switch in each position. See Fig 1 . If continuity is not as specified, or is poor in any switch position, replace ignition switch.
- Continuity should exist between terminals STA and B4 with ignition switch in START position only (start circuit). Continuity should not exist for all other switch positions.
- Continuity should exist between terminals P1 and GND with ignition switch in START position only (bulb check circuit). Continuity should not exist for all other switch positions.
- Continuity should exist between terminals B5 and I1 with ignition switch in START and RUN positions only (ignition circuit). Continuity should not exist for all other switch positions.
- Continuity should exist between terminals B5 and A1 with ignition switch in ACC position only. Continuity should not exist for all other switch positions.
- Continuity should exist between terminals A1 and B1 with ignition switch in RUN position only. Continuity should not exist for all other switch positions.
- Continuity should exist between terminals A2 and B2 with ignition switch in RUN position only. Continuity should not exist for all other switch positions.
- Continuity should exist between terminals A3 and B3 with ignition switch in RUN position only. Continuity should not exist for all other switch positions.
- Continuity should exist between terminals A4 and B4 with ignition switch in RUN position only. Continuity should not exist for all other switch positions.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
