1995 Ford Crown Victoria BaseFACTORY OEM SERVICE PROCEDURE

Keyless Entry System: Testing: Notes

NOTE: Keep driver's window rolled down when performing tests to prevent being locked out of vehicle.

A New Generation Star (NGS) Tester (007-00500) is required for testing the keyless entry system. The following tests make numerous references to DDM connectors and terminals. See Fig 1 .

Fig 1: Identifying Driver's Door Module Connector Terminals
G95I13548Courtesy of FORD MOTOR CO.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.