Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Ford Contour SE, AutomaticFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range |
|---|---|---|
| Camber (Degrees) Front | -0.5 | -1.1 to 0.1 |
| Camber (Degrees) Rear | N/A | N/A |
| Caster (Degrees) Front | 2.13 | N/A |
| Caster (Degrees) Rear | N/A | N/A |
| Toe-In (Inches) Front | -0.1 | -0.23 to 0.15 |
| Toe-In (Inches) Rear | N/A | N/A |
| Toe-In (Millimeters) Front | -2.5 | -6 to 4 |
| Toe-In (Millimeters) Rear | N/A | N/A |
| Toe-In (Degrees) Front | -0.2 | -0.46 to 0.3 |
| Toe-In (Degrees) Rear | N/A | N/A |
| Toe-Out On Turns (Inner-Front) | 20° | N/A |
| Toe-Out On Turns (Outer-Front) | 18.25° | N/A |
| Wheelbase (Inches) | 106 7/16 | N/A |
| Wheelbase (Millimeters) | 2704 | N/A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.