Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Switch
Remove window switch from vehicle. See appropriate POWER WINDOW SWITCH under REMOVAL & INSTALLATION . Using ohmmeter, check for continuity between switch terminals in specified switch positions. See the POWER WINDOW SWITCH TESTING table below. See Fig 1 , Fig 2 or Fig 3 . Replace power window switch if it does not test as specified.
| Switch Position | (1) Continuity Between Terminals No. | ||
|---|---|---|---|
| Neutral | A-1, A-2, A-3, A-4, | ||
| " | A-6, A-7, A-8, A-9 & B-3 | ||
| Right Front Up | A-2 & B-2; A-1 & B-3 | ||
| Right Front Down | A-1 & B-2; A-2 & B-3 | ||
| Right Rear Up | A-4 & B-2; A-3 & B-3 | ||
| Right Rear Down | A-3 & B-2; A-4 & B-3 | ||
| Left Rear Up | A-9 & B-2; A-8 & B-3 | ||
| Left Rear Down | A-8 & B-2; A-9 & B-3 | ||
| Left Front Up | A-6 & B-2; A-7 & B-3 | ||
| Left Front Down | A-7 & B-2; A-6 & B-3 | ||
|
|||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.