1994 Ford Probe Base, StandardFACTORY OEM SERVICE PROCEDURE

Control Unit Connector Resistance Check

  1. Turn ignition off. Verify ABS control unit connector is disconnected. Set DVOM on 2-k/ohm scale. Measure and record resistance between each of following ABS connector wire terminals. See PINPOINT TEST WSS-3 CIRCUIT IDENTIFICATIONΒ  table.
  2. If ALL resistances are between 1600-2000 ohms, go to PINPOINT TEST WSS-5Β  . If any resistance is not within specification, go to PINPOINT TEST WSS-4Β  .
PINPOINT TEST WSS-3 CIRCUIT IDENTIFICATION

Wire Color Application
Escort & Tracer
Black/White & Orange/White LF Wheel Speed Sensor
Black/Red & Orange RF Wheel Speed Sensor
Black/Blue & Red/Blue LR Wheel Speed Sensor
Black/Orange & White RR Wheel Speed Sensor
Probe
White & Red LF Wheel Speed Sensor
Yellow & Orange RF Wheel Speed Sensor
Yellow/Green & Yellow/Blue LR Wheel Speed Sensor
Green & Blue RR Wheel Speed Sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.