Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Checks: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1994 Mercury Grand Marquis, 1994 Mercury Cougar, 1994 Lincoln Town Car, 1994 Lincoln Mark VIII, and 1994 Ford Thunderbird. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If an ignition failure occurs, ignition system may operate with limited ability using Failure Mode Effects Management (FMEM). When this occurs, trouble codes should be present, engine may be hard to start and dwell and timing will not change.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.