Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location | |
|---|---|---|
| A/C Clutch Cycling Pressure Switch | In right rear corner of engine bay, on A/C accumulator. See Figure & Figure . | |
| A/C Clutch Thermal Protection Switch | In right front of engine bay, on A/C compressor. See Figure & Figure . | |
| A/C High Pressure Cut-Out Sw. (2.0L) | In right front of engine bay, forward of radiator. See Figure . | |
| A/C High Pressure Cut-Out/Fan Switch (2.5L) | In right front of engine bay, forward of radiator. See Figure . | |
| Back-Up Light Switch (M/T) | On left side of engine, on front of transaxle. See Figure & Figure . | |
| Brake Fluid Level Switch | In left rear of engine bay, on brake fluid reservoir. See Figure & Figure . | |
| Brake ON/OFF (BOO) Switch | On bracket, above brake pedal. See Figure . | |
| Clutch Pedal Position Switch | On bracket, above clutch pedal. See Figure . | |
| Inertia Fuel Shut-Off Switch | In luggage compartment, behind left rear interior trim panel. See Figure . | |
| Manual Lever Position Switch (A/T) | On front of transaxle. See Figure & Figure . | |
| Parking Brake Switch | At rear of center console, on parking brake assembly. | |
| Park/Neutral Position Switch (M/T) | ||
| 2.0L | On left side of engine, on top of transaxle. See Figure . | |
| 2.5L | On lower rear of transaxle. See Figure . | |
| Power Steering Pressure Switch | In power steering pressure line. See Figure & Figure . | |
| Seat Belt Switch | In driver's seat belt buckle. | |
| Starter Clutch Pedal Position Switch | On bracket, above clutch pedal. See Figure . | |
| Transmission Control Switch (TCS) | In front of center console. See Figure . | |
| Windshield Washer Fluid Level Switch | In washer fluid reservoir, in right front of engine bay. See Figure & Figure . | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.