1994 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C-Heater Blower Motor Resistor Behind right side of dash, in blower assembly. See Figure .
Program Connector In right rear of luggage compartment. See Figure .
Pulse Signal Generator (2.5L) On lower rear of transaxle. See Figure .
Radio Amplifier On right rear quarter panel, behind trim panel. See Figure .
Radio Noise Capacitor (2.0L) In left front of engine bay, near ignition coil. See Figure .
Sub-Woofer Amplifier On front of left quarter panel, behind trim panel. See Figure .
Test Connectors
Data Link Connectors (DLC) On left inner fender panel. See Figure & Figure .
Headlight Retractor On engine bay fuse/relay block.
Self-Test Input (STI) 2.0L On left inner fender panel. See Figure .
Spark Output (SPOUT) 2.0L On left inner fender panel. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.